Be sure and scroll down for our thread stands and needle threaders!

Madeira

    FS 20 Blackcore    80% viscose 20% metalliz.Pes., soft metallic, 612 yard spool in 28 colors

Mettler

     Seralene    100% Polyester, 60wt 2 ply, 2187 yard cones in 18 colors

Presencia

     60wt Cotton spools    100% Egyptian cotton 60wt 3 ply mercerized thread in 24 colors

Thread Stands

A must-have if you use any of the larger thread spools or cones. All metal base for stability. This is not one of the flimsy plastic ones - it's solid metal. This stand stays right where you put it!

Thread Stand - suggested retail $12.00  OUR PRICE $7.95 

Some assembly required - the tall post has a set-screw on the side. Unscrew it until the post drops in the hole and then screw it in tight to hold the post. The smaller post goes into the center hole. A good tap with a hammer will seat it in the hole. That's it, all done, ready to sew!

Needle Threaders

The older I get, the more I need these. The more I use them, the more I break the thin wire. The fancy ones are very pretty to look at but (in my humble opinion) break just as easy as the inexpensive ones! These may be cheap but they get the job done.

The package includes 3 threaders.

Needle Threaders, 3pk - suggested retail $.89  OUR PRICE $.55 

If you would like something a little nicer looking than the above threaders but still don't want to spend a fortune then give these a try. Made and packaged in the USA by the Roxanne company. This threader has a thin plastic "handle" (approximately 3/4" X 1") with the wire embedded in it. Very easy to grasp and a super thin wire, which was very hard to photograph!

The package includes 1 threader

Roxanne Needle Threader  - suggested retail $2.10  OUR PRICE $1.79 

© 2011 Purple Moose Designs